Sekonic LITEMASTER PRO - Page 11

11
g) Lift and remove the JR10-901(JR20-901) PCB / 1 Assy
*A little floating the substrate and shifted slightly to the left.
Out of the hole in the Main Frame Cover / F Assy of the USB connector cover, and then lift to remove
the PCB / 1 Assy.
Cautions during assembly
・
The screw tightening torque is to be 7～9cNm(6.9～8.8kgcm) (ZA348:M1.7×6 5pcs)
・When you set a PCB / 1 Assembly (JR10-901 / JR20-901) to a main part Main Frame Cover / F
Assembly (JR10-121 / JR20-121), be careful of a USB connector.
・When you attach FPC of Wire Harness / D Fold assembly (JR10-123) and a LCD Assembly
(JR10-129) main part, please show to spite and lock to the back of each connector of PCB / 1
Assembly (JR10-901 /JR20-901) of substrate.
・It attaches so that the projection at the tip of the LCD Holder Stay Assembly may go into the hole of
the angle of LCD. (Refer to the following figure)
ZA348(M1.7×6)
(two screws )
JR10-124
PCB Holder Part Assy
(2pcs.)
JR10-121(JR20-121)
USB hole of the Main Fram
e
Cover / F Assy.
JR10-901(JR20-901)
PCB/1 Assy
USB connector
JR10-901(JR20-901)
A
lso on the left side th
e
PCB / 1 Assy.
JR10-129
LCD Assembly
JR10-125
LCD Holder Stay Assembly
B
A