Sencore Impulse 300D - Page 37

Impulse 300D – User Manual
Page 37 (67)
Disabled
Interface
Network 1
Network 2
The physical connector on the MPEG/IP card
that will be used to transmit the output.
Destination IP
Multicast - 224.0.0.0
- 239.255.255.255
When sending to a unicast address the
destination IP address must match the
receiving device’s IP address. When sending a
multicast the address must be sent within the
multicast IP range.
Destination Port
0 - 65535
When sending to a unicast address, the
destination port must match the receiving
device’s port. When sending a multicast, any
port within the accepted range can be used, but
it is good practice to always choose a port
>1030 and an even number
Source IP Mode
Auto
Manual
Enables automatic or manual source IP
address
Source IP
0.0.0.0 –
255.255.255.255
Source IP for stream
Source Port
0 - 65535
This is the port used by the IMPULSE 300D to
transmit the MPEG/IP stream.
Source MAC Mode
Auto
Manual
Enables automatic or manual source MAC
address input
Source MAC
00:00:00:00:00:00 –
FF:FF:FF:FF:FF:FF
Source MAC address for the stream
TS Packets Mode
Auto
Manual
Enables automatic or manual TS packet per IP
packet selection
TS Packets Per IP
Packet
1-7
The number of TS packets that are contained
with a single IP packet. Default is 7. Lowering
this value below default increases network
overhead.
Differentiated
Services
Default
Assured Forwarding
1-1 to 4-3
Expedited
Forwarding
Define the quality of service (QoS) classification
the packets carry when transmitted.
Encapsulation
UDP
RTP
Sets the Encapsulation to UDP or RTP.