Sencore Impulse 300D - Date;Time

Impulse 300D – User Manual
Page 45 (67)
4.3.8 Date/Time
The IMPULSE 300D can be set to synchronize with an NTP server or a manual date and
time can be defined by the user. Click the button to configure the date
and time. These values are used to timestamp entries in the Alarm and Event logs under
the Reporting tab.
Setting
Range
Description
Update Mode
NTP
Manual
Setting to NTP uses the local network’s NTP
server to synchronize date and time. Manual
allows the user to define a date and time.
NTP Server
Four decimal octets:
XXX.XXX.XXX.XXX
Domain Name
This is the IP Address or Domain Name of the
local NTP Server on the network. This setting is
only available if Update Mode is set to NTP.
Date
MM/DD/YYYY
This setting is the user defined date. A calendar
widget can be used to select the data by clicking
the button. This setting is only available if
Update Mode is set to Manual.
Time
00:00:00 – 24:00:00
This setting is the user defined time. The time is
based on a 24 hour clock. This setting is only
available if the Update Mode is set to Manual.