Impulse 300D – User Manual
Page 59 (67)
Appendix B – Error and Event List
Without AC3 license and audio type is AC3.
Audio is corrupted in incoming stream or format is not
supported.
The Date/Time setting of the system was changed.
The system has detected an instance of packets being dropped.
HLS Bitrate Exceeded
Error
Total incoming transport stream bitrate has exceeded 20 Mbps.
HLS Receive Connection
Error
The system encountered a connection error when receiving HLS
transmission.
Native format of incoming video is not a supported audio format.
Native format of incoming video is not a supported video format.
Mpeg/IP Bitrate Exceeded
Error
Total incoming transport stream bitrate has exceeded 60Mbps.
Mpeg/IP Transmit Unicast
Reciever Not Found
The system was unable to detect the configured unicast
receiver.
Service Lock service selection mode is enabled but no services
are present in the active input transport stream.
The system cannot connect to the configured NTP server.
The NTP Date/Time was updated.
RIST Bitrate Exceeded
Error
Total incoming transport stream bitrate has exceeded 30 Mbps.
RIST Receive Connection
Error
The system encountered a connection error when receiving
RIST connection.
RIST Receive Lost
Packets Error
The system has detected lost packets in the received RIST
signal.
RIST Transmit
Connection Error
The system has detected a connection error when transmitting
SRT signal.
RIST Transmit Lost
Packets Error
The system has detected lost packets in the transmitted SRT
signal.
RTMP Bitrate Exceeded
Error
Total incoming transport stream bitrate has exceeded 30 Mbps.
The system has detected an error in RTP reception.
SRT Bitrate Exceeded
Error
Total incoming transport stream bitrate has exceeded 30 Mbps.
SRT Receive Connection
Error
The system encountered a connection error when receiving SRT
transmission.
To Next Page
Loading...
