Sencore Impulse 300D - Configuring the MPEG;IP Transmit

Impulse 300D – User Manual
Page 36 (67)
4.2.5 Configuring the MPEG/IP Transmit
This menu allows the user to configure the MPEG/IP output. The two network ports can
be set to either receive or transmit MPEG/IP. This menu is for setting up the
transmission of MPEG/IP unicast or multicast transport streams.
Setting
Range
Description
Transmit Type
MPEG/IP
The selection of which protocol to transmit from
the device
Transmit
Enabled
Enable or disable the MPEG/IP transmit group.