Using the “Conference Manager” software
128 | ADN Digital Conference System
왘 Enter the max. number of speakers who can take the floor simultaneously into
the “Microphone Limit” field.
Setting the maximum number of
requests to speak
The setting adjusted in the “Request Limit” field becomes effective only if you are
using a chairperson unit (“Request” mode) or if you have selected “Direct Access”
mode.
For information on how this setting affects your conference, refer to the section
“Adjusting the conference mode” (see page 126).
Adjustment range: “0” ... “10”
왘 Enter the max. number of requests to speak into the “Request Limit” field.
Activating/deactivating the flashing
of the signal light ring when a
request to speak is made
왘 Tick/untick the “Blink on Request” check box.
Activating/deactivating the
speaking time limit
The “Talk Time Limitation” check box allows you to activate/deactivate the
speaking time limit. The duration of the speaking time limit, the advance warning
time, and the activation of an optical warning signal can be set individually.
왘 Tick/untick the “Talk Time Limitation” check box.
To set the speaking time limit:
왘 Enter the speaking time into the “Talk Time Limit” field.
Adjustment range: “1” ... “60”, adjustable in steps of 1 minute
To set the advance warning time:
왘 Select the desired advance warning time from the “Premonition Time” drop-
down list.
Adjustment range: “00” ... “120”, adjustable in steps of 10 seconds
Check box Behavior when a request to speak is made
is ticked When a participant makes a request to speak, the micro-
phone LED flashes green and the signal light ring
flashes red.
is unticked When a participant makes a request to speak, the micro-
phone LED flashes green.
If you make a new request to speak, the speaking time countdown is
started again.
Check box Behavior
is ticked The speaking time is limited to the time period set.
is unticked The speaking time is not limited.
To Next Page
Loading...
