ADN Digital Conference System | 43
Putting the conference system into operation
Connecting the media control system to the central unit
To enable communication between the central unit and the media control system:
왘 Make sure that the network communication between the central unit and the
media control system is not blocked by a proxy server and/or a firewall.
Port 53252 is used for communication.
왘 Connect the media control system to the central unit via the IP address of the
central unit. The central unit serves as a socket server and communicates with
the media control system via TCP and port 53252. For more information on
setting the IP address of the central unit, refer to the following chapters:
– “Adjusting network settings – “Network” submenu” on page 70,
– “Adjusting the network settings” on page 84,
– “Adjusting network settings” on page 98.
Programming the media control system
Depending on the media control system used, you can individually program
the graphical interface and the operating sequences and adapt them to your
requirements.
You can find all information on the control commands and output instructions of
the conference system for programming the media control system in the PDF doc-
ument “ADN_MediaCtrl_Protocol.pdf” included on the DVD-ROM (supplied with
the central unit) or at www.sennheiser.com.
For more questions on the integration of the ADN conference system into a media
control system, contact your Sennheiser partner.
To Next Page
Loading...
