Configuring the conference system
20
Configuring the conference system
This chapter provides information on how to quickly and easily configure
the consoles of your conference system (but not the consoles of the
interpretation system) using the software.
For configuring the conference system, you require the S-MM (Microphone
Management) software module which is started as follows:
왘 Click and select , and one after the other.
Then click .
The “SDC 8000” window opens.
The “SDC 8000” window consists of:
y the menu bar
If you have not licensed all of the software modules, some of the menus
will not be available in your software.
y the “Start” button
for starting an already existing conference configuration
y the status bar
shows the current date, the current time and the state of the COM
connection to the central unit (“Connected” or “Disconnected”)
To Next Page
Loading...
