43
Trigon-6 Operation Manual
Sequencer
Clock
Sets the internal master clock for both the Sequencer and Arpeggiator.
BPM: 30…250—Sets the tempo for the Sequencer and Arpeggiator in BPM
(beats per minute). The tap tempo LED ashes at the BPM rate. When lfo
sync is turned on, the BPM rate affects the LFO frequency. When syncing to
an external MIDI clock source, the BPM setting has no effect.
Tap Tempo: 30…250—Tap this button at least 4 times to quickly set the
tempo for the Sequencer and Arpeggiator. The LED ashes at the BPM
rate you set.
Divide: Sets the note value for each sequencer/arpeggiator step relative
to the BPM. divide works with both internal and external clock sources.
The following table lists the values:
Name Tempo Timing Division
Half BPM/2 Half note
Qtr BPM Quarter note
8th BPM x 2 Eighth note
8th D BPM x 2 Eighth note, dot
8th S BPM x 2 Eighth note, swing timing
8th T BPM x 3 Eighth note triplets
16th BPM x 4 Sixteenth note
16th S BPM x 4 Sixteenth note, full swing timing
16th T BPM x 6 Sixteenth note triplets
32nd BPM x 8 Thirty-second note
To Next Page
Loading...
