82
Appendix D: Support
Sequential
Recovering from a Failed OS Udate
In very rare cases, the Trigon-6 OS might fail to load correctly when you
update. There is now a safe and easy way to recover in such situations.
The Trigon-6 is now equipped with a MIDI boot loader, which will allow
you to reload the OS in the event the you accidentally “brick” your synth
(permanently freeze it) while updating its OS.
To restore your Trigon-6 if it is frozen.
1. Power on the Trigon-6 while holding the write switch to enter boot
loader mode. You’ll see an animation in the main display.
2. Use a MIDI cable (not USB) to transmit the new OS to your synth. You
must use a standard MIDI cable for this. USB MIDI doesn’t work in
boot loader mode.
3. As the OS loads, you will see the main display count backwards from
999. When it gets to 0, another countdown will begin between the main
display and the effects parameter 1 display. Do not power down until
this countdown has nished. The Trigon-6 will restart itself when it is
done.
If your Trigon-6 is currently equipped with OS 1.2 (which is included with
Trigon-6 serial numbers #2415 and later) you cannot downgrade to an OS version
earlier than 1.2. If you try, your Trigon-6 will freeze. If this happens, you can enter
recovery mode by holding the write button while powering up as described above.
You can then update your synth to the latest OS via MIDI DIN (not USB).
To Next Page
Loading...
