50
Write
Sequential
To choose the Key Assign mode:
1. Press and hold key mode in the misc parameters section. The numeric
display shows the currently selected mode.
2. To select a different mode, continue to hold down the key mode switch
then press the bank/decrement and tens/increment switches to step
through the other choices.
3. Release the key mode switch when you’re nished.
Key Assign settings are only relevant to Unison mode. They do not affect poly-
phonic playback.
Using Unison in a Poly-Chained System
In a poly-chained system, the maximum number of voices available in
unison mode is 12 voices. In a non-poly chained system, Unison gives
you control over how many voices to stack — from 2 to 6 voices.
In a poly-chained system, stacking options are slightly different. You
can choose to stack either 2, 3, 4, 5, or 12 voices. In other words, setting
voice stacking above 5 voices will stack all 12 voices. There are no
options for stacking 6, 7, 8, 9, 10, or 11 voices in a poly-chained system.
To use Unison:
1. Press and hold the unison switch.
2. With the Unison switch held down, use the bank/decrement and tens/
increment switches to choose the number of voices to stack (2, 3, 4, 5,
or 12 voices) then release the Unison switch.
3. To detune the oscillators, use the slop knob.
To Next Page
Loading...
