62
Performing OS Updates in a Poly-Chained System
Sequential
Performing OS Updates in a Poly-
Chained System
In a poly-chained system, updating the operating systems of both synths
can be done in tandem. This requires connecting the two synths as
described below. Note that the OS update must be passed to the rst
Trigon-6 using its midi in port. You cannot use the USB port to perform
the OS update in this case.
To enable two poly-chained Trigon-6s to be updated in tandem:
1. With a MIDI cable, connect your MIDI interface to the midi in port of
the rst Trigon-6.
2. Connect the rear-panel midi thru of the rst Trigon-6 to the midi in of
the second Trigon-6.
3. Perform the OS update in the normal way. See the instructions included
with the OS update for step-by-step instructions.
To Next Page
Loading...
