60
Using USB
Sequential
Calibrating the Pitch and Mod Wheels
In general, the Pitch and Mod wheels shouldn’t require re-calibration.
However, if you experience what seems like a persistent problem with
either of them, the Trigon-6 has built-in auto-calibration procedure that
you can use to remedy the problem.
To calibrate the Pitch and Mod wheel’s low position:
1. Rotate and hold both wheels in their low position.
2. Hold down the preset button and press 7.
To calibrate the Pitch wheel’s center position:
• With the Pitch wheel centered, hold down the preset button and press 8.
To calibrate the Pitch and Mod wheel’s high position:
1. Rotate and hold both wheels in their high position.
2. Hold down the preset button and press 9.
Resetting the Global Parameters
If you’re trying to track down a problem, it’s sometimes a good idea to
reset the Global parameters to their defaults. This is a quick way to make
sure that the Trigon-6 returns to its factory settings.
To reset all Global parameters to their default settings:
• Hold down the global button and press write.
To Next Page
Loading...
