Sequential TRIGON-6 - Aftertouch Parameters

57
Trigon-6 Operation Manual
Aftertouch
Amount: Selects the amount of aftertouch applied to a selected destina-
tion. Positive amount settings apply positive amounts of modulation.
Negative amount settings apply negative amounts of modulation.
Freq 1: Selects Oscillator 1 frequency as an aftertouch modulation desti-
nation. With a positive amount setting, pressing the keys harder will shift
the Oscillator 1 pitch upward. With a negative amount setting, pressing
the keys harder will shift the Oscillator 1 pitch downward.
Freq 2: Selects Oscillator 2 frequency as an aftertouch modulation desti-
nation. With a positive amount setting, pressing the keys harder will shift
the Oscillator 2 pitch upward. With a negative amount setting, pressing
the keys harder will shift the Oscillator 2 pitch downward.
Freq 3: Selects Oscillator 3 frequency as an aftertouch modulation desti-
nation. With a positive amount setting, pressing the keys harder will shift
the Oscillator 2 pitch upward. With a negative amount setting, pressing
the keys harder will shift the Oscillator 2 pitch downward.
Filter: Selects the Low-Pass Filter cutoff frequency as a modulation destina-
tion. With a positive amount setting, pressing the keys harder will open
the lter wider and make a sound become brighter. With a negative
amount setting, pressing the keys harder will close the lter more and
make a sound more muted.
Controlling the low-pass or high-pass lter frequency with Aftertouch may or
may not have an audible effect, depending on the cutoff frequency of the lter.
Amp: Selects Amplitude as an aftertouch modulation destination. With
a positive amount setting, pressing the keys harder will increase the
volume of a sound. With a negative amount setting, pressing the keys
harder will decrease the volume of a sound.
LFO : Selects the lfo amount parameter as an aftertouch modulation
destination. With a positive amount setting, pressing the keys harder will
increase the amount of LFO modulation to any destination selected in
the lfo section. With a negative amount setting, pressing the keys harder
will increase the amount of LFO modulation — with the LFO waveform
inverted.