SEUIC Technologies Co., Ltd.
Ensure battery is charged
Scanner successfully decodes the barcode, but data not transmitting to host
Host interface not configured properly
Scan appropriate host parameter bar codes
Ensure all cable connections are secure.
Scanner not paired to cradle
Scan cradle pairing bar code.
Scanner can not decode the barcode
Corresponding code system is not enabled
Enable the corresponding code system
Ensure the bar code is not defaced; try
scanning a test bar code of the same bar
code type.
Distance between scanner and bar code
incorrect
Move scanner closer to, or further from bar
code.
The scanner cannot communicate and charge normally when placed on the cradle
Poor contact between scanner and cradle
Try to tighten the Battery Compartment
Knob
Scan the "Cradle mode" barcode, switch
the Bluetooth mode to the Cradle mode,
and then try to pair again
The Bluetooth HID mode cannot search for the Bluetooth device of the wireless
scanner, and cannot be paired and connected
The wireless scanner is paired with other
mobile phones/computers
1. Scan the "Clear Pairing Info of Bluetooth
HID Mode" barcode
2. Search for Bluetooth and pair again
The wireless scanner has been paired
before, and the pairing information on the
mobile phone/computer has not been
cleared
1. Enter the Bluetooth setting interface on
the mobile phone/computer to delete the
paired device information
2. Search for Bluetooth and pair again
Scan the "Bluetooth HID Mode" barcode,
switch the Bluetooth mode to the Cradle
mode, and then try to pair again
To Next Page