About This Manual：
HS220 wireless scanners are factory programmed for the most common terminal and communications
settings.You can change these settings in the following two ways：
1）By scanning menu barcodes
2）By sending serial commands to the scanner
3）An asterisk (*) next to an option indicates the default setting
Chapter 1 General Settings
1.1 Restore the Scanner and the Cradle factory default settings
（the USB keyboard interface (HID) is set by default.）
1.2 Restore the Scanner factory default settings
By pressing and holding the Trigger button to power on the scanner, and then press and hold the Trigger
button for 30 seconds,you can also set the scanner to factory default values.
1.3 Restore the Cradle factory default settings
By pressing and holding the Page button for 60 seconds,you can also set the cradle to factory default
values.
（the USB keyboard interface (HID) is set by default.）
1.4 Show Scanner serial number information
Scan this code to show the scanner serial number information.
1.5 Show Cradle serial number information
Scan this code to show the cradle serial number information.
To Next Page