SEW-Eurodrive DFE24B EtherCAT - Assembly and Installation Notes; Installing DFE24 B Option Card

Manual – Fieldbus Interface DFE24B EtherCAT®
11
4
Installing the DFE24B option card in MOVIDRIVE
®
MDX61B
Assembly and Installation Notes
4 Assembly and Installation Notes
This section provides you with information on assembly and installation for the DFE24B
option card in MOVIDRIVE
®
MDX61B, MOVITRAC
®
B and the UOH11B gateway hous-
ing.
4.1 Installing the DFE24B option card in MOVIDRIVE
®
MDX61B
4.1.1 Before you start
Plug the DFE24B option card into the fieldbus slot.
Observe the following notes before installing or removing an option card:
• Disconnect the inverter from the power. Disconnect the DC 24 V supply and the line
voltage.
• Take appropriate measures (discharge strap, conductive shoes, etc.) to protect the
option card from electrostatic charge before touching it.
• Before installing the option card, remove the keypad and the front cover (see
MOVIDRIVE
®
MDX60B/61B operating instructions, "chapter Installation").
INFORMATION
• Only SEW-EURODRIVE personnel may install or remove option cards for
MOVIDRIVE
®
MDX61B size 0.
• Users may only install or remove option cards for MOVIDRIVE
®
MDX61B sizes 1
to 7.
• Plug the DFE24B option card into the fieldbus slot [1].
• The DFE24B option is powered with voltage via MOVIDRIVE
®
B. A separate volt-
age supply is not required.
6052434187
[1] Fieldbus slot
[1]
DFS11B
01
2
2
2
2
0
1
2
3
2
2
2
AS
4
5
6
X30
1
6
5
9
01
2
2
2
2
0
1
2
3
2
2
2
4
5
6
2
7
2
8
2
9
F-ADDRESS X31
FSR
FDOBF
12
34
56
FDO
LS
PS