SEW-Eurodrive DFE24B EtherCAT - Installing the DFE24 B Option Card in MOVITRAC B; Connecting the System Bus (Sbus 1) between a MOVITRAC; B Unit and the DFE24 B Option

14
Manual – Fieldbus Interface DFE24B EtherCAT®
4
Installing the DFE24B option card in MOVITRAC
®
B
Assembly and Installation Notes
4.2 Installing the DFE24B option card in MOVITRAC
®
B
4.2.1 Connecting the system bus (SBus 1) between a MOVITRAC
®
B unit and the DFE24B option
INFORMATION
•MOVITRAC
®
B does not require a special firmware status.
• Only SEW-EURODRIVE may install or remove option cards for MOVITRAC
®
B.
6764955147
[1] S12 = ON (terminating resistor activated)
[2] S2 = OFF (reserved)
X45
X46
1
23456HL ⊥
FSC11B
MOVITRAC
®
B
S1
OFF
ON
7
S2
X44
X26
1234567
X24
H1
H2
X12
1
2
3
4
5
6
7
8
24V IO
DC 24 V
–
+
9
GND
=
[1]
01
F1
EtherCAT
AS
RUN
DFE 24B
ERR
INX30OUTX31
OUTX31
[2]
INFORMATION
• DFE24B has an integrated SBus terminating resistor and must always be installed
at the start of the SBus connection.
• DFE24B always has the SBus address 0.
X46 X26 Terminal assignment
X46:1 X26:1 SC11 SBus +, CAN high
X46:2 X26:2 SC12 SBus –, CAN low
X46:3 X26:3 GND, CAN GND
X46:7 X26:7 DC 24 V
X12 Terminal assignment
X12:8 DC 24 V input
X12:9 GND reference potential for binary inputs