SEW-Eurodrive MOVIMOT flexible MMF1 C/DBC Series - Page 220

8
Service
Fault/error table
Operating Instructions – MOVIMOT
®
flexible
220
Subfault: 16.25
Description: User-defined current limit too low for standstill current
Response: Output stage inhibit
Cause Measure
User-defined current limit value too small for min-
imum standstill current.
Increase the user-defined current limit, or disable
the standstill current function.
Subfault: 16.26
Description: Nominal values incomplete or implausible
Response: Output stage inhibit
Cause Measure
During startup using nameplate data: Nominal
voltage, nominal current, nominal speed or nom-
inal torque are not entered or are not plausible.
Enter or check nominal voltage, nominal current,
nominal speed, and nominal torque.
Subfault: 16.27
Description: Maximum current or maximum torque not plausible
Response: Output stage inhibit
Cause Measure
During startup using nameplate data: Maximum
current or maximum torque not entered, or maxi-
mum current and maximum torque not plausible.
Check the maximum current and maximum
torque.
Subfault: 16.30
Description: Faulty EtherCAT
®
EEPROM configuration state
Response: Warning
Cause Measure
Faulty EtherCAT
®
/SBus
PLUS
EEPROM configura-
tion status.
EEPROM not loaded; binary file not loaded.
Contact the SEW‑EURODRIVE Service.
Faulty EEPROM loading procedure. Contact the SEW‑EURODRIVE Service.
Faulty EEPROM checksum. Contact the SEW‑EURODRIVE Service.
Subfault: 16.40
Description: Data of selected motor not valid
Response: Output stage inhibit
Cause Measure
Startup data set on replaceable memory module
not valid for this motor.
Replace the memory module.
29129451/EN – 12/2019