Sharp AR-M550U - Process Adsorption Plate; Drum Separation Pawl Solenoid; OPC Drum Cleaner Temperature Sensor; Discharge Lamp

: Feb. 6 2004
1
AR-M550/M620/M700 DETAILS OF EACH SECTION 6 - 80
4) Remove the brush roller.
a-7. Process adsorption plate
1) Remove the drum unit.
2) Remove the cover to remove the adsorption plate.
a-8. Drum separation pawl solenoid
1) Disconnect the connector, and remove the harness guide unit.
2) Remove the drum separation pawl solenoid.
a-9. OPC drum cleaner temperature sensor
1) Remove the upper cover.
2) Remove the OPC drum cleaner temperature sensor.
a-10. Discharge lamp
1) Remove the upper cover. (See “a-9. OPC drum cleaner tempera-
ture sensor” in this section)
2) Remove the discharge lamp.
∗ Be careful not to break the pawl when fixing.
1
A