AR-M550/M620/M700 OTHER 12 - 13
B. Inserter (AR-CF2) paper jam judgment conditions
*1) The take-up position is 30mm downstream from the vertical path transport roller.
*2) The reverse stop position is 20mm downstream from the reverse sensor.
JAM CODE Name
JAM detection method
JAM judge distance
JAM detection start trigger JAM judge detector
REG_SEN_N Resist sensor not-reached
JAM
Separation start Resist sensor ON (Distance from pick descending start to
resist sensor ON) x 5
REG_SEN_S Resist sensor remaining
JAM
Transport start from the
take-up position (*1)
Resist sensor OFF Max. document length (WLT) - (Resist
sensor OFF to take-up position) + 200mm
TIM_SEN_N Timing sensor not-reached
JAM
Resist sensor ON Timing sensor ON Distance from resist sensor ON to timing
sensor ON + 200mm
TIM_SEN_S Timing sensor remaining
JAM
Resist sensor OFF Timing sensor OFF Distance from resist sensor OFF to timing
sensor OFF + 200mm
HI_SEN_NI Paper exit sensor not-
reached JAM (Inserter
paper feed)
Timing sensor ON Paper exit sensor ON Distance from timing sensor ON to paper
exit sensor ON + 200mm
HI_SEN_NP Paper exit sensor not-
reached JAM (Main unit
paper feed)
Main unit paper exit
command receive
Paper exit sensor ON Distance from main unit side to paper exit
sensor ON + 500mm
HI_SEN_S Paper exit sensor remaining
JAM (Main unit paper feed)
After passing by 20mm from
the paper exit sensor ON
Paper exit sensor
OFF
Max. document length (WLT) + 200mm
Paper exit sensor remaining
JAM (Inserter paper feed)
Timing sensor OFF Paper exit sensor
OFF
Distance from timing sensor OFF to paper
exit sensor OFF + 200mm
H_SEN_NIN Reverse sensor not-
reached JAM (When
entering the reverse path)
Timing sensor ON Reverse sensor ON Distance from timing sensor ON to reverse
sensor ON + 100mm
H_SEN_NOUT Reverse sensor not-
reached JAM (When exiting
from the reverse path)
Switchback start Reverse sensor ON Distance from reverse stop position (*2) to
reverse sensor ON + 100mm
H_SEN_SIN Reverse sensor remaining
JAM (When entering the
reverse path)
Timing sensor OFF Reverse sensor OFF Distance from timing sensor OFF to reverse
sensor OFF + 100mm
H_SEN_SOUT Reverse sensor remaining
JAM (When exiting from the
reverse path)
After passing 20mm from
the reverse sensor ON
Reverse sensor OFF Max. Document length (WLT) + 100mm
MM
MM
MM
FUM
POM1
POM2
TM1X
TM2X
DVM
DM
ADM1
ADM2
VPM
TRM
SPFM
SPSM
SLUMB
K_MOT
LTM
M1
M6
M2
M7
M8
M2S
M3S
M5S
M8S
M4S
M2P
M1P
MM
MM
MM
M1LUM
T2LUM
T1LUM
M2LUM
FUM
POM1
H_MOT
K_MOT
Y_MOT
M1
M9
M2P
M1P
M6 M4
M2
M7
M3
M8
M5
M10
M1S
M2S
M6S
M7S
M3S
M5S
M8S
M4S
POM2
TM1X
TM2X
DVM
DM
ADM1
ADM2
VPM
LLM
LTM
TRM
SPFM
SPSM
MIM
SLUMB
Motor cross section
To Next Page
Loading...
