AR-M550/M620/M700 DETAILS OF EACH SECTION 6 - 123
4) Remove the separation roller. (Refer to "b-1. Separation roller" in
this section.)
5) Remove the paper feed paper guide lower unit in the arrow direc-
tion.
6) Remove the bearing metal fixture, and remove the torque limiter.
7) Remove the electromagnetic clutch. (See “b-3. SPF resist roller
brake clutch” in this section)
8) Remove the plastic E-ring to remove the bearing.
9) Slide the No. 1 resist roller drive in the arrow direction, and remove
the plastic E-ring.
10) Remove the No. 1 resist roller drive in the arrow direction.
b-7. SPF paper transport roller 2 brake clutch
b-8. SPF paper transport roller 2 clutch
1) Remove the rear cover. (See “a-1. Cabinet” in the previous sec-
tion, “[External outfit section]”)
2) Disconnect the connector, and remove the plastic E-ring, the SPF
paper transport roller 2 brake clutch (A), and the SPF paper trans-
port roller 2 clutch (B).
b-9. Transport roller 2 (Drive)
b-10. Transport roller 1 (Drive)
1) Remove the cabinet. (See “a-1. Cabinet” in the previous section,
“[External outfit section]”)
2) Remove the document feed tray unit. (See “a. Paper feed unit” in
this section)
3) Remove the No. 1 resist roller idle and the paper feed paper guide
lower unit. (See “b-5. No. 1 resist roller (Drive)” in this section)
4) Remove the plastic E-ring on the cover side to remove the link
lever.
A
B
To Next Page
Loading...
