: Feb. 9 2004
1
AR-M550/M620/M700 SIMULATION 8 - 20
C. Details
Operation/Procedure
1) Select the operation mode with 10-key.
2) Press START key.
The scanner performs scanning at the speed corresponding to the
operation mode.
Operation/Procedure
The sensor and detector operation conditions are displayed.
The active sensors and detectors are highlighted.
• The scanner (read) unit is in the home position.: "MHPS" section is
highlighted.
• The scanner (read) unit is not in the home position.: "MHPS" is nor-
mally displayed.
Operation/Procedure
1) Select the operation mode with 10-key.
2) Press START key.
The SPF repeat paper feed, transport, and paper exit at the speed
corresponding to the operation mode.
The operation can be stopped by [CUSTOM SETTINGS] key.
Operation/Procedure
The operating conditions of the sensors and detectors are displayed.
The active sensors and detectors are highlighted.
1
1-1
Purpose Operation test/Check
Function
(Purpose)
Used to check the operations of the scanner (read) unit
and its control circuit.
Section Optical (Image scanning)
Item Operation
1 HIGH SPEED High speed (220mm/s)
2 LOW SPEED Low speed (110mm/s)
Press [START] key, and the
operation is started.
Press [CUSTOM SETTINGS] key, and scanning
is stopped.
1-2
Purpose Operation test/Check
Function
(Purpose)
Used to check the operation of sensor and detector in
the scanning (read) section and the related circuit.
Section Optical (Image scanning)
Item Operation
MHPS Optical system home position
SIMULATION 1-1
SCANNER CHECK. SELECT 1-2, AND PRESS START.
1. HIGH SPEED
2. LOW SPEED
1
SIMULATION 1-1
SCANNER CHECK. EXECUTING···.
1. HIGH SPEED
2. LOW SPEED
1
SIMULATION 1-2
SCANNER SENSOR CHECK..
MHPS
2
2-1
Purpose Operation test/Check
Function
(Purpose)
Used to check the operations of the automatic
document feeder unit and the control circuit.
Section DSPF
Item
Operation
1 HIGH SPEED (220 mm/sec) High speed
2 LOW SPEED (110 mm/sec) Low speed
3 TOP SPEED (360 mm/sec) Top speed
Press [START] key, and the
operation is started.
Press [CUSTOM SETTINGS] key, and the
operation is stopped.
2-2
Purpose Operation test/Check
Function
(Purpose)
Used to check the operations of the sensors and
detectors in the automatic document feeder unit and
the related circuits.
Section DSPF
Item Operation
SSET SPF sensor
SOCD Open/close sensor
SCOV Paper feed cover sensor
SPED2 Document set sensor (Lower)
SPED1 Document set sensor (Upper)
SPPD1 Document transport sensor 1
SPPD2 Document transport sensor 2
SPPD3 Document transport sensor 3
SPPD4 Document transport sensor 4
SPOD Document exit sensor
SWDn Document width sensor (n → 1 (inside) - 6 (outside))
SPLSn Document length sensor (n → 1 (inside) - 2 (outside))
CISSET CIS installation detection
STSET Stamp unit installation sensor
STUD Tray upper limit sensor
STLD Tray lower limit sensor
SWD_LEN SPF guide plate position (unit: 0.1mm)
SWD_AD SPF document width detection volume output AD
value
SIMULATION 2-1
SPF AGING TEST. SELECT 1-3, AND PRESS START.
1. HIGH SPEED
2. LOW SPEED
3. TOP SPEED
2
SIMULATION 2-1
SPF AGING TEST. EXECUTING···.
1. HIGH SPEED
2. LOW SPEED
3. TOP SPEED
2
To Next Page
Loading...
