: Feb. 9 2004
1
AR-M550/M620/M700 SIMULATION 8 - 2
Led edge void set value
Rear edge void set value
Side edge setting
Print off-center adjustment value
Resist amount adjustment value
Laser power adjustment value
PPD1 sensor adjustment
Process correction inhibit allow set value
Developing bias rising correction wait time
Developing bias rising correction adjustment value
Built-in finisher jogger position adjustment
Saddle adjustment value
Counters Adjustment value Other
(Data saved by the scanner control PWB)
1
Counters Adjustment value Other
Scan counter Document lead edge adjustment value Exposure mode set value
SPF paper pass counter Document off-center adjustment value Scanner serial number
SPF stamp counter Document image loss amount adjustment value Document image loss amount adjustment value
Magnification ratio adjustment value
SPF resist amount adjustment value
Exposure motor speed adjustment value
Platen document detection adjustment value
SPF size width detection adjustment value
Touch panel adjustment value
Exposure level adjustment value
ϒ change value
OC/SPF exposure correction value
Shading adjustment value (CCD/CIS)
CCD shading start position adjustment value
(Data saved by the MFP control PWB)
Counters Adjustment value Other
Copy counter FAX SOFT SW., etc. Trouble history
Printer counter JAM history
FAX receive counter Destination setting
FAX send counter Language setting
All valid paper counter Toner save mode setting
Trouble counter 13" setting
JAM counter Auditor setting
Counter mode setting
Trouble memory mode setting
Center binding mode AMS setting
PC/MODEM communication trouble detection
YES/NO setting
Tag number set value
Printers set values
Network set value
1
To Next Page
Loading...
