To avoid paper jams, make sure the tray is securely inserted.
• The upper limit differs depending on paper type; thin paper or thick paper. Check the label inside
the tray to confirm the upper limit.
• The remaining paper indicator on the right front side of the paper tray shows approximately how
much paper is remaining.
• For details about paper types supported by the machine, see p.82 "Paper and Other Media".
• For details about the paper settings, see p.114 "Specifying Paper Type and Paper Size".
Loading paper longer than A4
This section explains how to load paper longer than A4 (297 mm) into the machine.
• Before printing on paper other than envelopes, make sure that the fusing unit levers inside the front
cover are pulled up. Leaving the levers lowered can cause print quality problems when printing on
paper other than envelopes.
• Make sure paper is not stacked above the limit mark inside the tray. Misfeeds might occur.
• After loading paper in the tray, specify the paper type and size using the control panel to avoid
printing problems. This machine does not detect the paper size automatically.
• Do not mix different types of paper in the same paper tray.
• Do not move the side paper guides forcefully. Doing so can damage the tray.
• Do not move the end paper guide forcefully. Doing so can damage the tray.
• When inserting the tray, make sure it is not slanted. Inserting it at a slant can damage the machine.
Loading Paper
99
To Next Page
Loading...
Need help?
General
