Using Manuals
Be sure to read this section before any other part of this manual.
• This manual uses procedures based on Windows XP as an example, unless otherwise specified.
Procedures and screens might vary depending on the operating system you are using.
Opening Manuals
This section describes how to open the manuals. There are three ways to view the manuals.
Follow the procedure below to open the manual from the CD-ROM.
• The following procedure is based on Windows XP as an example. If you are using another
operating system, the procedure might vary slightly.
1. Insert the manual CD-ROM into the CD-ROM drive.
If you are using a computer running a Macintosh operating system, open "Manuals.htm" from the
CD-ROM root directory.
2. Select a language for the interface and a product, and then click [OK].
3. Click [Read PDF manuals], and then select the manual you want to read.
The manual opens.
• If you are using a computer running a Windows operating system, the CD-ROM opens
automatically. However, AutoRun may not work under certain operating system settings. If this is
the case, launch “setup.exe” from the CD-ROM root directory.
1. Guide to the Machine
18
To Next Page
Loading...
Need help?
General
