4. Using the Copier Function
This chapter describes the copier functions.
The Screen in Copier Mode
This section provides information about the screen when the machine is in copier mode.
By default, the display shows the copier screen when the machine is turned on.
If the scanner or fax screen is shown on the display, press the [Copy] key on the control panel to switch
to the copier screen.
1. Current status or messages
Displays the current status or messages.
2. Current settings
Displays the current tray, reproduction ratio, and scan settings.
3. Selection key items
If function names appear on the bottom, you can use them by pressing the corresponding selection keys.
4. Copy quantity
Displays the current copy quantity. You can change the copy quantity using the number keys.
• The start-up mode can be specified in the [Function Priority] setting under [Admin. Tools].
153
To Next Page
Loading...
Need help?
General
