In copier mode In scanner mode In fax mode
Left 3 mm 0 mm 1 mm (Letter, Legal)
0 mm (other sizes)
Bottom 3 mm 2 mm 2 mm
Placing Originals
This section describes the procedure for placing originals on the exposure glass and in the ADF.
• Do not place originals before any correction fluid and toner has completely dried. Doing so may
make marks on the exposure glass that will appear on copies.
• The original in the ADF takes precedence over the original on the exposure glass if you place
originals both in the ADF and on the exposure glass.
• Because colors made by marker or highlighter pen on originals are difficult to reproduce, they
might not appear on copies, or might appear as different colors.
Placing originals on the exposure glass
The exposure glass enables you to scan and send documents that cannot be fed into the ADF.
• Do not lift the ADF forcefully. Otherwise, the cover of the ADF might open or be damaged.
1. Lift the ADF.
Be careful not to hold the input tray when lifting the ADF, for the tray might be damaged.
2. Getting Started
120
To Next Page
Loading...
Need help?
General
