44
USING SETTINGS STORED AS A PROGRAM
This function allows you to store the steps of an operation, including the destination and scanning settings, into a
program. This function is convenient when you frequently send documents, such as a daily report, to the same
destination. Up to nine programs can be stored.
When storing a program, a name (maximum 36 letters) can be assigned to the program.
For information on storing, editing, and deleting programs, see "STORING, EDITING AND DELETING PROGRAMS" on page 76.
The following settings can be stored in a program:
(1) Transmission method
Normal transmission (page 17), broadcast transmission (page 31), polling (page 35), serial polling (page 37),
F-code transmission (page 59), F-code polling (page 57)
(2) Cover sheet / message (page 43)
(3) Resolution and exposure (page 14)
(4) Dual page scan (page 42)
(5) Transmission settings (page 22)
When storing a broadcast transmission or serial polling operation in a program, up to 200 destination fax numbers can be stored.
USING A PROGRAM
1
In fax mode, place the original. (Page
12)
Skip this step if polling, serial
polling, or F-code polling is being
performed. If you are going to use
Dual Page Scan (page 42), place
the document on the Document
glass.
(To select fax mode, see step 1 on page 17.)
2
Press the [PROGRAM] key.
The program selection
screen appears.
3
Select the program that you wish to
use with the [ ] or [ ] key.
If not all letters of the program name appear, press the
key to display all letters. Press the key once
again to return to the original screen.
4
Press the [OK] key.
5
If needed, select the original size and
other settings, and then press the
[START] key ( ).
Transmission takes place according to the program.
• A program differs from a timer transmission (page 33) in that it is not cleared from memory after transmission
takes place. A program thus allows you to repeatedly perform the same type of transmission. Note, however,
that programs do not allow you to establish a timer setting for transmission.
• A setting that can be stored in a program cannot be changed at the time that a program is used for a
transmission even if the setting is not stored in the program.
•
The only settings that can be selected when using a program are the original size, duplex scanning, and a timer setting.
Note
PROGRAM
A CORP.
B CORP.
- - - - - -
[#]:LIST DETAIL
Select settings that cannot be stored in a
program before you press the [START] key
( ) in step 5. These settings include the
original size (see "MANUALLY SETTING
THE SCANNING SIZE" on page 13), duplex
scanning (see "FAXING A TWO-SIDED
ORIGINAL
(MX-M182D/MX-M202D/MX-M232D)" on
page 21), and a timer setting (see
"AUTOMATIC TRANSMISSION AT A
SPECIFIED TIME (TIMER
TRANSMISSION)" on page 33).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
