Sharp MX-M202D - Using F-Code Polling Memory

55
TRANSMISSION USING F-CODES
4
USING F-CODE POLLING MEMORY
In order for another machine to retrieve a document from your machine, you must first scan the document into the
F-code polling memory box.
You can check the document in the memory polling box by printing it out.
(See "Checking and clearing document data in a box" on page 56.)
Scanning a document into an F-code polling memory box
The procedure for scanning a document into an F-code polling memory box (page 81) is in general the same as
"Scanning a document into polling memory (the Public Box)" on page 38.
1
Perform steps 1 through 4 of
"Scanning a document into polling
memory (the Public Box)" (page 38).
2
Select "S.A.M-POLL ORIG" with the
[ ] or [ ] key.
3
Press the [OK] key.
4
Select the name of the polling memory
box with the [ ] or [ ] key.
If not all letters of the programmed name appear,
press the key to display all letters. Press the key
again to return to the previous display.
When using F-code polling memory, do not set the reception mode to manual reception.
Note
About the steps that follow
See steps 6 through 10 in "Scanning a document
into polling memory (the Public Box)" (pages 38 to
39). Where "public box" (page 38) appears in the
procedure, substitute "F-code polling memory box".
PQ
ACC
LEX SCAN
LEX SCAN
DED COPY
SELECT READING
MEMORY POLLING
S.A.M-POLL ORIG
GHI
PQRS
BACK
OK
SEL S.A. POLL BX
Document Plan
Document Tech
- - - - - -
[#]:LIST DETAIL