57
TRANSMISSION USING F-CODES
4
PROCEDURE FOR F-CODE POLLING
Make sure that a document has not been placed in the document feeder tray or on the document glass, and then
follow the steps below.
1
In Fax mode, press the [SPECIAL
FUNCTION] key.
When the [SPECIAL
FUNCTION] key is pressed, the
special function selection
screen appears.
(To select fax mode, see step 1
on page 17.)
2
Select "SENDING OPTIONS" with the
[ ] or [ ] key.
3
Press the [OK] key.
4
Select "SUB ADD POLLING" with the
[ ] or [ ] key.
5
Press the [OK] key.
6
Enter the fax number of the other
machine with the numeric keys, or
press a Rapid key, or dial a Speed Dial
number (a group key cannot be used).
To clear a mistake when
entering a number with the
numeric keys, press the [C] key
to clear one digit at a time.
A destination selected with a Rapid key or Speed Dial
number is indicated by an icon and a number. To clear
an entry, press the [C] key.
7
Press the [OK] key.
8
Enter the sub-address (up to 20 digits)
with the numeric keys.
• Characters that can be entered are numbers, "#",
and spaces. However, the initial character cannot be
a space.
• If you make a mistake, press the [C] key and re-enter
the correct digit(s).
• If you specified a Rapid key or Speed Dial number in
step 6 that has a sub-address programmed, the
sub-address will appear. Go to the next step without
entering a sub-address.
9
Press the [OK] key.
• You must know the sub-address (SEP) and passcode (PWD) of the other machine's F-code polling memory
box.
• Serial polling (selecting multiple fax machines to be polled using a group key, Rapid keys, and Speed Dial
numbers) is not possible when using F-code polling.
Note
To Next Page
Loading...
Need help?
General
Weight and Dimensions
