76
PROGRAMMING
STORING, EDITING AND DELETING PROGRAMS
You can store a transmission method*, cover sheet/message, transmission settings, dual pages, and/or
resolution/exposure settings in a program. This will allow you to use the settings for a transmission by means of a
simple operation (see "USING A PROGRAM" on page 44).
* Transmission methods: normal transmission, broadcast transmission, polling, serial polling, F-code transmission,
F-code polling
To store a program, follow steps 1 through 6 on pages 66
to 67 and then follow the steps below.
1
Select "ENTRY" with the [ ] or [ ] key.
2
Press the [OK] key.
3
Select "PROGRAM" with the [ ] or
[ ] key.
4
Press the [OK] key.
5
Select "ENTER", "CHANGE", or
"DELETE" with the [ ] or [ ] key.
• To store a program, select "ENTER" and press the
[OK] key. Continue from step 6 of "STORING A
PROGRAM".
• To edit a program, select "CHANGE" and press the
[OK] key. Next, follow the steps in "EDITING
PROGRAMS" on page 77.
• To delete a program, select "DELETE" and press the
[OK] key. Next, follow the steps in "DELETING
PROGRAMS" on page 77.
[STORING A PROGRAM]
6
Select the program that you wish to
store with the [ ] or [ ] key.
If you select a program that has already been stored, a
message appears. Select a program that has not been
stored, or clear the program (page 77) and then select
it.
7
Press the [OK] key.
8
Enter a program name (see
"ENTERING CHARACTERS" on page
86).
Up to 36 characters can be stored for the name of the
program. A program name must be entered.
9
Press the [OK] key.
An original size setting, screen setting, and timer transmission setting cannot be stored in a program.
Note
To Next Page
Loading...
