72
PROGRAMMING
[Editing and deleting auto-dial numbers]
To edit or delete an auto-dial number, follow steps 1 through
6 on pages 66 and 67 and then follow the steps below.
● Editing a Rapid key or Speed Dial number
1
Select "RAPID/SPEED" with the [ ] or
[ ] key.
2
Press the [OK] key.
3
Select "CHANGE" with the [ ] or [ ]
key.
4
Press the [OK] key.
5
Press a Rapid key ([01] to [50]) or the
[SPEED] key.
• To edit a Rapid key, press the Rapid key that you
wish to edit ([01] to [50]).
• To edit a Speed Dial number, press the [SPEED] key
and then enter the Speed Dial number (000 to 299)
that you wish to edit with the numeric keys.
6
Edit the destination fax number with
the numeric keys.
Move the cursor to the digit(s) that you wish to edit with the [ ] or
[ ] key, and then enter the correct digit(s) with the numeric keys.
To delete a digit, move the cursor to the digit that you wish to
delete with the [ ] or [ ] key and then press the [C] key.
7
Press the [OK] key.
8
Edit the name of the destination (see
"ENTERING CHARACTERS" on page 86).
9
Press the [OK] key.
10
Edit the search characters (see
"ENTERING CHARACTERS" on page 86).
Characters added in step 8 will appear at the end of
the previously stored search characters. (Maximum of
10 characters altogether.)
A Rapid key or Speed Dial number cannot be
edited or cleared in the following cases:
• The Rapid key or Speed Dial number is
being used in a transmission in progress
or in a stored transmission.
• The Rapid key or Speed Dial number is
stored in a group key, program, or F-code
relay group.
Note
To Next Page
Loading...
Need help?
General
Weight and Dimensions
