1-147
BEFORE USING THE MACHINE►PERIPHERAL DEVICES
PUNCH MODULE (MX-PN13B)
The punch module can be installed on a finisher (100-sheet stapling) or saddle stitch finisher (100-sheet stapling) to
punch holes in paper to be output.
DISCARDING PUNCH WASTE
Punch waste from punched holes is collected in the punch waste box.
Follow the operation procedure to replace punch waste.
A saddle stitch finisher or finisher (100-sheet stapling) is required to install the punch module (100-sheet punching).
1
Open the front cover.
2
Grasp the punch waste box handle,
gently pull out the box, and discard the
punch waste.
Discard the punch waste in a plastic bag or other container,
taking care not to let the waste scatter.
To Next Page
Loading...
