Sharp MX-M905

2-44
COPIER►BASIC PROCEDURE FOR MAKING COPIES
STAPLE SETTINGS
Specify whether or not the set of output will be stapled.
*1 When a finisher (50-sheet stapling) or saddle stitch finisher (50-sheet stapling) is installed, the staple position is
parallel to the edge of the paper.
*2 When a finisher (50-sheet stapling) or saddle stitch finisher (50-sheet stapling) is installed.
Image Orientation Staple
Staple Position
Left Top Right
- Off Does not staple.
Portrait orientation
1 Staple*
1
2 Staples
1 Staple (Diagonal)*
2
Landscape orientation
1 Staple*
1
2 Staple
1 Staple (Diagonal)*
2
• You can view staple positions on the "PREVIEW SCREEN (page 1-17)". Text will be printed at the preset size regardless
of the copy ratio or paper size setting.
• To change the default staple position:
In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Initial Status Settings] → [Staple Position].
• A finisher or saddle stitch finisher is required to use the staple function.
• A saddle stitch finisher is required to use the saddle stitch function.