7-9
MANUAL FINISHINGâ–ºOPERATION OF MANUAL FINISHING
USING MANUAL FINISHING
Change from the Home Screen or each mode to manual finishing mode, and carry out the following procedure.
â–º SELECTING MANUAL FINISHING MODE (page 7-3)
OPERATION OF MANUAL FINISHING
1
Set the guides to the size of the paper.
Grasp the guide lock lever to adjust the guide.
When you have finished the adjustment, release the lock
lever.
When loading paper larger than 8-1/2" × 11"R, or A4R, extend the bypass tray all the way out. If it is not pulled all the
way out, the size of the loaded paper will not be detected correctly.
2
Load paper into the upper or lower
tray.
The paper orientation varies depending on the manual
finishing function.
â–º CHECKING TYPE AND SIZE OF PAPER
(page 7-5)
â–º PAPER LOADING ORIENTATION (page 7-6)
• Up to 200 sheets of paper can be loaded into each of the upper and lower trays.
• Insert the paper along the guides all the way into the tray.
• If the guide width is not correctly adjusted to match the paper width, paper may be jammed, skewed, or crease. Adjust
the paper guides to fit the width of the paper.
3
Select the appropriate finishing
method.
â–º STAPLE FUNCTION (page 7-11)
â–º PUNCH FUNCTION (page 7-14)
â–º PAPER FOLDING FUNCTION (page 7-15)
8½x11
8½x11
Upper Tray
Output Tray Inserter
Staple
Off
1 Staple
at Back
Saddle
Fold
Half Fold
C-Fold
1 Staple
at Front
2 Staples
Saddle
Stitch
Off
Off
Accord-
ion Fold
Copies/Pages
Type and Size
Double
Fold
Z-Fold
Detail
Punch Fold
Middle Tray
Lower Tray
Start
CA
Upper Tray
Lower Tray
Plain 1
Plain 1
2 Hole
Punch
To Next Page
Loading...
Need help?
General
