— 140 —
Direct Key Programming
Use the following procedure to select direct-key programming:
Direct PLU/COMBO/Dept. key
You can assign PLUs, combo meals and departments directly to the keyboard. In the case of combo meals or
PLUs, you may assign up to 5-levels to be accessed directly on the keyboard.
Procedure
In the case of setting “00020 DIRECT PLU”
1.
In the SETTING window, select “02 DIRECT KEY.”
• The DIRECT KEY window will appear.
• TYPE (Use the selective entry method)
PLU : Assigns the key as a direct PLU key.
COMBO : Assigns the key as a direct combo key.
DEPT : Assigns the key as a direct department key.
NOTE
•You can also select a direct PLU key by pressing the corresponding key
when the PLU has been assigned directly on the keyboard instead of
selecting the key from the menu.
•When selecting a department, the screen on which a department code
is to be entered (the message “DEPT. CODE”) will appear.
• When selecting a combo, the screen on which a combo table number is
to be entered (“COMBO TBL#”) will appear.
• LEVEL1 thru 5 (Use the numeric entry method)
Enter a PLU number or combo table number for each level.
For example, if you want to use this key as PLU code 1 (level 1) and
PLU code 101 (level 2), enter 1 for the “LEVEL1” and 101 for the
“LEVEL2.”
Press the key on the keyboard
you wish to program or select the
desired key no. from the key
numbers list (Refer to the next
page).
To Next Page
Loading...
Need help?
General
