— 21 —
Mode selection window
Selecting an Operating Mode
2
When you turn on the POS terminal and press the
MODE
key, a mode selection window will
appear on the display, listing available operating modes as shown below.
Operating Modes
You can select any mode other than REG from the list in the mode selection window. Your POS terminal supports
the following eight operating modes:
REG mode
OPX/Z mode
OFF mode
X1/Z1 mode
X2/Z2 mode
PGM1 mode
PGM2 mode
SD Card mode
This mode allows you to enter various sales information. The mode selection window
does not list this mode. To select this mode from the mode selection window, press
the
CANCEL
key.
This mode allows cashiers/servers to take X or Z reports on their sales. It can also be
used to specify the number of hours for which employees work.
This mode locks all the operational functions of the POS terminal. When you select
this mode, the window will disappear. Pressing any key turns the POS terminal "ON."
This mode is used to take various daily total reports (X1/Z1 reports).
This mode is used to take various weekly or monthly reports (X2/Z2 reports).
This mode allows you to program those items which need to be frequently changed,
such as unit prices of departments or PLUs and percentages.
This mode allows you to program those items which can be programmed in the PGM1
and need not be frequently changed, such as date, time and functions.
This mode allows you to save the data of your POS terminal to an SD card or load the
data saved in the SD card on the terminal.
To Next Page
Loading...
Need help?
General
