— 243 —
Automatic Sequencing Key Programming
If you program AUTO keys (automatic sequencing keys) for frequently performed key operations, you can enter
those key operations simply by pressing the corresponding AUTO keys.
Procedure
To program automatic sequencing keys as follows:
1.
Select the automatic sequencing key which you want to program.
2.
Enter the desired sequence for the automatic sequencing key in the
programmed sequence.
750
4
CA/AT
3.
To end programming for the key, touch “EXIT” in the lower left corner
of the display.
4.
To program another automatic sequencing key, repeat the above
steps.
5.
To end programming automatic sequencing keys, press the key.
Select “03 AUTO KEY” from the
PGM2 window.
To Next Page
Loading...
