— 223 —
Negative Code File Programming
Use the following procedure for negative code file programming:
Negative code/Override status
You can program the negative code and its override status.
Procedure
Program each item as follows:
• NEGATIVE# (Use the numeric entry method)
Negative code (max. 16 digits)
• OVERRIDE (Use the selective entry method)
Negative code checking can be overridden in compliance with
programmed override status.
(Override/access operation:
)
(Not to override:
CANCEL
)
REG&MGR: Available to the manager and servers/cashiers.
The message “ACCESS” is displayed.
MGR ONLY: Only availanle to the manager.
The message “CALL MGR” is displayed.
INHIBIT: The override operation is inhibited.
The message “NOT ACCEPT” is displayed.
NOTE
• You can create a new code by entering the code, then pressing the
ENTER
key.
To delete a negative code, proceed as follows:
Enter the code or move the cursor to the code, and then press the DEL
key.
Select a negative code and press
ENTER
.
(Or enter the corresponding code.)
To Next Page
Loading...
Need help?
General
