— 25 —
Prior to Entries
5
Preparations for Entries
NOTE
Receipt/Journal paper rolls
If the paper rolls are not installed in the built-in printer of your POS terminal, install a new one (ones) according to
section "Installing and Removing the Paper Roll" under "Operator Maintenance." If the roll in the printer is getting
low, replace it with a new one.
Receipt ON/OFF function
You can disable receipt printing in the REG mode to save paper using the receipt On/Off function. To disable
receipt printing, press the
FUNC
MENU
key and then touch the
RCP
ON/OFF
key. Set the function to "OFF" by pressing the key.
When this function is in the OFF state, the Receipt Off Indicator "R" is highlighted. To enable receipt printing, touch
"RCP ON/OFF" with this function in the OFF state.
Your POS terminal will print reports regardless of the state of the Receipt ON/OFF function. This means
that the paper roll(s) must be installed even when the Receipt ON/OFF function is preset to "OFF".
In the following examples, your POS terminal will go into an error state accompanied by a warning beep and the
error message on the display. Clear the error state by pressing the
CL
key and take a proper action.
• When you exceed a 32-digit number (entry limit overflow):
Cancel the entry and reenter a correct number.
• When you make an error in key operation:
Clear the error and try the entry again.
• When you make an entry beyond a programmed amount entry limit:
Check to see if the entered amount is correct. If it is correct, it can be rung up by the manager. Contact your
manager.
• When an including-tax subtotal exceeds eight digits:
Delete the subtotal by pressing the
CL
key and press a media key to finalize the transaction.
Error Warning
To Next Page
Loading...
Need help?
General
