Sending a Fax by Automatic Dialling
35
2. Sending
Faxes
1
If you are sending a fax, load the
document(s).
• If desired, press to set the
resolution and/or contrast.
2
Press once. <REDIAL> appears in the display, followed by the last
number dialled. Make sure the number that appears is the number you
wish to dial.
3
If you are sending a fax, press . Dialling and transmission begins.
If you are making a phone call, lift the handset. Dialling begins.
Note: If a fax transmission is unsuccessful and DOCUMENT JAMMED
appears in the display, remove the document as explained on page 77. (This
may occur if the other fax machine doesn’t respond properly when you
attempt to send the document.)
RESOLUTION
/RECEPTION
START/MEMORY
Redial
You can automatically redial the last number dialled. This procedure can be
used to send a fax or make a phone call.
Automatic redialling
If you use automatic dialling (including Direct Keypad Dialling) to send a fax
and the line is busy, the fax machine will automatically redial the number. The
fax machine will make three redial attempts at an interval of five minutes.
During this time, RECALLING will appear in the display, followed by a two-digit
number assigned to the fax job. You will not be able to dial any other locations
while the message appears.
♦ To stop automatic redialling, press .
♦ Under certain conditions (for example if a person answers the call on a
telephone), automatic redialling may stop before two redialling attempts are
made.
STOP
READY TO SEND
all.book Page 35 Wednesday, October 27, 2004 12:42 PM
To Next Page
Loading...
Need help?
General
