Sharp UX-P520

Using TEL Mode
43
3. Receiving
Faxes
1 Answer the extension phone when it
rings.
2 If you hear a soft fax tone, wait until your fax responds (the extension
phone will go dead), then hang up.
3 If the fax doesn't respond, or if the other party first talks to you and then
wants to send a fax, press once and twice on the extension
phone (only on a tone dial phone). This signals the fax to begin
reception. Hang up.
Phone goes dead
Beep
Answering on an extension phone
Important: If a document is loaded in the machine’s feeder, remove it before
performing the steps below. (Fax reception is not possible when a document
is in the feeder.)
all.book Page 43 Wednesday, October 27, 2004 12:42 PM