Shimadzu EI-D3203M - Page 64

6.6 Software Operation
51
Power Supply Unit
INSTRUCTION MANUAL
6
The number of alarms that occur for the
magnetic bearing system at speeds
exceeding 80% of the rated speed is
counted. If this number exceeds 10,
alarm code 11 (number of high-speed
touch-downs alarm)
occurs.
Select Reset Counter
The number of warning that occur for
the magnetic bearing system is counted.
Select Reset Counter
INTEFRATING TIMER
MB ALARM=999
at 2003/12/31 23:59
SET
SELECT
SET
INTEGRATING TIMER
MB WARNING=999
at 2003/12/31 23:59
+-
SET
SELECT
SET
MB ALARM=999
RESET COUNTER= NO
SELECT SET
MB WARNING=999
RESET COUNTER= NO
SELECT SET
from2003/12/31 23:59
from2003/12/31 23:59
+-
at 2003/12/31 23:59
from2003/12/31 23:59
Reset TIME
Update TIME
INTEGRATING TIMER
MB ALARM=999
Number of TOUCH
DOWN
MB ALARM=999
RESET COUNTER=NO
Press the + or -
key to select between
NO or YES
INTEGRATING TIMER
MB WARNING=999
Number of Magnetic
Bearing Warning
at 2003/12/31 23:59
from2003/12/31 23:59
Reset TIME
Update TIME
MB WARNING=999
RESET COUNTER=NO
Press the + or -
key to select between
NO or YES