• Dante™ Virtual Soundcard / Controller: Turn on the Dante™ Virtual Soundcard and use the controller software to route the array microphone signal to
the computer.
• Web Conferencing Software:Assign the audio input and output device settings to the appropriate Dante transmitter and receiver channels.
③ Network switch to ANI4OUT
Use network cables to connect each ANI4OUT to the network switch. Each interface receives 4 channels of Dante audio, and converts them to 4 analog signals,
delivered through XLR outputs or block connectors.
④ Audio from far end to amplifier
Route the far end audio to an amplifier.
⑤ Amplified audio signal to loudspeakers
Connect the loudspeakers to the amplifier to deliver the audio from the far end.
Shure IncorporatedMXA910 Ceiling Array Microphone
2017/10/1812/57
To Next Page
Loading...
