⑦ IP Mode
Sets IP mode of the selected network interface:
• Auto (DHCP): For automatic assignment of IP addresses.
• Manual (Static): For Static IP addresses.
⑧ IP Settings
View and edit the IP Address, Subnet Mask, and Gateway for each network interface.
⑨ MAC Address
The network interface's unique identification.
⑩ Density Mode
Sets the density mode set on the APT:
• Standard density (default)
• High density (doubles the available channels)
⑪ RF Mode Settings
For APT2 and APT4 installed in adjacent rooms, alternate modes (Mode A, Mode B) to get the best RF performance.
⑫ Add Updates
Select Add Updates to save the device changes to the control software. All device properties are updated simultaneously from the Utility tab. Once saved, the
device will show Pending under the Properties column.
⑬ Cancel Updates
Remove any changes made to the device properties.
Preferences Tab
All preferences apply to each device in the Configuration.
① Switch Behavior
Customize the switch on each transmitter type.
• Toggle (default): Press and release the button to change the status to Active or Mute.
• Push-to-talk: Hold button to pass audio.
• Push-to-mute: Hold button to mute the audio.
• Disabled: The button does not affect the audio.
② Initial State from Charger
Assigns the state for the transmitter after it has been removed from the charger:
• Active: On and passing audio to the network.
• Mute: On but the audio is muted.
• Standby: On but in a 'sleep' state with audio muted. Standby conserves battery charge and enables a change to the transmitter's status from the control
software.
• Off: Power is off. A transmitter in this state cannot be remotely controlled by the software.
Shure IncorporatedMXW
53/722017/05/17
To Next Page
Loading...
