126
NICE
The duplication process should be carried out in the
immediate proximity of the receiver CU.
1. Press for about 7 seconds the button you want to encode on
the new RC.
2. Press the operating RC button 3 times in succession.
3. Press the new RC button again.
Wait at least 10 seconds and try to open the gate with the fresh
programmed RC. To duplicate further RCs repeat the process
starting from point 1.
If the process is not successful or if errors are made during
programming, wait 20 seconds and start the programming
process again from point 1.
FLO2R-S
Cod. 6900908
FLO2R-S
Cod. 6900909
Compatible with Nice ONE, VERY-VR, NICE FLO2RE, ON2E, INTI RCs
DUPLICABLE THROUGH UNIVERSAL RCs
EVO
LITE
433.92 MHz
Rolling code
To Next Page
Loading...