43
433.92 MHz
Fix codes
Best position
for duplication
CLASSIC 724
SELF-LEARNING
Cod. 4790724
CLASSIC 724
1. Select 3 buttons, including the one on which you want
to memorise the desired program, then press them
simultaneously.
2. The 4790724 will flash 4 times to confirm that the switch to
programming mode has been completed.
3. Release 2 buttons and keep pressing only the one you want
to program.
4. Position the two remote controls as shown in the figure,
now press the button on the original remote control (to be
copied) and wait for 3 flashes from remote control 4790724
to confirm programming*.
5. Before releasing the already memorised button, press a
further blank button to continue programming by releasing
the already memorised button.
6. Before releasing the already memorised button, press a
further blank button to continue programming by releasing
the already memorised button.
7. If a button is released by mistake, repeat the whole process
from point 1.
*In some cases it is advisable to position the remote controls
back to back.
If the procedure is unsuccessful or mistakes occur during
programming, wait 20 seconds and start the programming
process again from point 1.
To Next Page
Loading...