63
JCM APERIO
1. Place the working remote control in front of the new remote
control.
2. Press and hold the button to duplicate on the old RC.
3. Press both buttons on the new remote control, which will
flash three times once the code has been memorised.
Process on the receiver
1. Press and release the programming button on the receiving
board. (P, PG, PROG, M, REC, CH1, ENR, MEMO).
2. Press and hold the button on the new remote control for 5
seconds.
3. Wait 15 seconds and try to operate the automation to check
that the RC is working properly.
GO MINI
Cod. 6904200
Compatible with RC GO PRO 4
868.35 MHz
Rolling code
DUPLICABLE THROUGH UNIVERSAL RCs
EVO
To Next Page
Loading...