168
TELECO
The duplication process should be carried out in the
immediate proximity of the receiver CU.
1. Press the internal button P3 of a transmitter already in
memory; the enabled receiver emits a continuous sound for
5 sec.
2. Within 5 sec. transmit a channel present in the receiver
memory which must memorise the new code; the buzzer
will interrupt the sound for 1 sec. and resume for another 5
sec. (this operation is used to address the new code to the
desired receiver).
3. Within 5 sec. transmit the new channel to memorise. The
successful memorisation is signalled by an intermittent
sound of the Buzzer.
If the process is not successful or if errors are made during
programming, wait 20 seconds and start the programming
process again from point 1.
ILIKE TVTXE868A02
Cod. 6901130
ILIKE TVTXE868A04
Cod. 6901135
Compatible with TVTX 868 RC
868.35 MHz
Rolling code
To Next Page
Loading...